![]() ![]() In this case check the setting of the transmitter and the programming of the speed controller or readjust throttle servo, carburetor position and throttle linkage rod. Since this will have a negative effect on the control behavior of the system, this throttle position can not be used. If the Status-LED lights up in red the distance between the lowest throttle position and the full throttle position is too small. This means that a new valid throttle position has been detected. ![]() The Status-LED must light up in blue color. Move the throttle stick to full throttle position. Otherwise there are no differences between the modes „electric“ and „nitro“. So you can set the full throttle position quite comfortable without the motor running high (we expect that your maximum stick position actually indicates the maximum throttle position of your ESC in case your ESC is setup correctly!). In „electric“ mode the throttle output will stay locked. Here the output can be only controlled by the throttle stick when the RPM Governor type is set to „nitro“. At menu point C you have to set full throttle position of your ESC or throttle servo. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |